Common Golf Club Regripping Mistakes To Avoid
When it comes to golf, having a good grip on the club can make all the difference in your swing and your score. Over time, the grips on your clubs can wear down and lose their effectiveness, which is why it’s important to know how to regrip your golf clubs.
While this may seem like a simple task, there are some common mistakes that many golfers make when regripping their clubs. Let’s take a look at some of the most common golf club regripping mistakes and how to avoid them so that you can keep that perfect swing.
Not Cleaning the Golf Shaft Before Regripping
Before you even think about adding a new grip, it’s essential to thoroughly clean your golf club’s shaft. This step allows you to remove any old residue, dirt, and oils. Failing to clean the surface can result in a less secure bond between the grip and the shaft, which could lead to issues with slippage and reduced performance during play.
Use grip solvent to remove any lingering traces of adhesive. Then wipe the entire length of the shaft with rubbing alcohol. After cleaning, let the club air dry for a few minutes before moving on to the regripping process.
Using Too Little Grip Tape
Grip tape is an essential component of the regripping process, as it provides the necessary adhesion between the grip and the shaft. Skimping on grip tape will result in a weaker connection, potentially leading to the grip slipping or twisting over time.
Be precise when applying your grip tape to ensure a secure fit and optimal performance. Wrap it around the entire length of the shaft where you plan to place the grip. Be sure to leave an excess of about half an inch at the end, which you can fold into the shaft’s opening before sliding the new grip on.
Not Using Enough Solvent
Solvent plays a crucial role in regripping, as it helps to clean the shaft and aids in the installation of the new grip. Failing to apply enough solvent can make it very difficult to slide the new grip onto the shaft, potentially resulting in an uneven or misaligned installation.
It’s important to use a liberal amount of solvent during the regripping process. Remember to apply solvent both directly onto the grip tape and inside the new grip to ensure a smooth and secure installation.
Not Removing All Liners From Tape
When working with double-sided grip tape, it’s vital to remember to remove all paper liners from both sides of the tape. This measure will expose the sticky surface required for a successful grip installation.
Forgetting to remove the paper from one or both sides will lead to a lack of adhesion and, ultimately, a loose grip, which can negatively impact your game performance. Double-check that you’ve removed all paper liners from both sides of the tape before applying it to the shaft to avoid this simple yet costly mistake.
By being mindful of these common golf club regripping mistakes, you’ll be well on your way to improving your game with a fresh set of grips.
If you’re looking for grip tape that can withstand even the toughest of tournaments, use Brampton Technology’s golf club grip kits. As the creator of the original Complete Grip Kit and an expert in creating better bonds, our grip tape will last round after round.